Receiver Description：

1, the working voltage: DC24V2.Load current,：10A3. the load power: 2200W4, quiescent current: 8mA5, operating frequency: 315MHz,6, receiving sensitivity: -105dbm7, frequency deviation: ± 0.2MHz8, coding method: learning type9, working mode: jog, self-locking, interlocking10, modulation method: ASK11, remote control distance: 50M (wild)12. PCBA size: 32mm*35mm*18mm13, shell size: 40MM * 37MM * 25MM

Function selection:

1. Set to jog output: Remove the jumper cap on the board.2. Set as self-locking output: short the “T” and the middle pin with the jumper on the board.3, set to interlock output: use the jumper cap on the board to short "L" and the middle pin.Learn to code.(Note "Learning code" means "matching"):1, power to the circuit board, LED light.2. Press the KEY button on the PCBA board. After the LED goes out, release the button.3. Press any key on the remote control and the LED will blink.4, learning code OK.Clear original code:1, power to the circuit board, LED light.2. Press the KEY button on the PCBA board and do not release it.3. After seeing the LED flash, release the button.4, clear OK.

Output mode explanation:

1. Self-locking/Toggle : Press the remote controller "A" once to pull the relay. Press the remote controller "A" again and the relay turns off.2. Interlock/Latched : Press the "A" key of the remote control and the relay will pull in. Press the remote control "B" key, the relay is off.3. Jog/Momentary : press the remote control "A" key, the relay pulls, release the remote control "A" key, the relay is disconnected. If you keep pressing it, the relay will keep on pulling until you release the "A" key of the remote controller