The HDMI Wireless Extender provides an easy way to extend HDMIsianals wirelessly up to 656 feet (200 meters). It extends HDMI content from computers , set-top boxes, Bluray players, and other HDMI sources to remote HDMI-compliant display(s).

Features:

●This wireless HDMI extender is comprised of a Transmitter unit and a Receiver unit●Support loop-out at transmitter end for easy monitorinc●Support wide range of resolutions including 480i/576i - 1080p@50/60Hz, SVGA-WUXGA.●External antenna support long range of transmission up to 656 feet (200 meters)●Support IR extension for source device control at the display end●Support OSD for monitoring device status●Plug and play, no need drivers for PC installation

Receiver ports layout

1. Mouse keyboard input interface2. MODE button: Click to switch display mode (lighting for mode 1), and long press toswitch channel bit (lighting for mode 2).3. PWR light: Lighting when power is supplied.4. LINK light: Flashing when data is transmitting.5. STA light: Flashing when data is transmitting.6. Mode 1 light (Display mode): Lighting off for Graphic Mode with shorter latency, andlighting on for Video mode with less package lost rate.7. Mode 2 light (Channel bit): Lighting on to adjust high-bit channel, and lighting off to adjustlow-bit channel.8. Channel signal9. ID button: Click to switch channel ID.10. Switch mode: Display the screen of the transmitter with the same channel ID when use itas N to 1.11. Splitter mode: Direct connection to transmitter. No channel ID should be set.12. Antenna13. DC IN port: Requires 12V/1A power supply.14. Reset hole: When plug in the power,Long press the reset button for over 9 seconds toreset to factory default settings.15. HDMI OUT port: Connects to monitor with HDMI port for display.16. Audio out port: Audio output to other speakers. Note that HDMI output port sends audiosimultaneously.17. IR IN port: Supports IR input for remote control.18. Antenna

Transmitter ports layout

1. USB PORT: FW upgrade2. MODE button: Click to switch display mode (lighting for mode 1), and long press to switchchannel bit (lighting for mode 2).3. PWR light: Lighting when power is supplied.4. LINK light: Flashing when data is transmitting.5. STA light: Flashing when data is transmitting.6. Mode 1 light (Display mode): Lighting off for Graphic Mode with shorter latency, andlighting on for Video mode with less package lost rate.7. Mode 2 light (Channel bit): Lighting on to adjust high-bit channel, and lighting off to adjustlow-bit channel.8. Channel signal9. ID button: Click to switch channel ID.10. Switch mode: Display the screen of the transmitter with the same channel ID when useit as N to 1.11. Splitter mode: Direct connection to transmitter. No channel ID should be set.12. Antenna13. DC IN port: Requires 12V/1A power supply.14. Reset hole: When plug in the power,Long press the reset button for over 9 seconds toreset to factory default settings.15. HDMI OUT port: Connects to monitor with HDMI port for display.16. HDMI input: Connects to your device (laptop or computer box).17. IR IN port: Supports IR input for remote control.18. Antenna

Installation

Splitter Mode Display (1 to 1):1.Position the toggle switch to Splitter Mode on both Receiver and Transmitter.2.Connect power to 12V/1A and a monitor to display output on Receiver.3.Connect Receiver and Transmitter by The same one HDMI cable to pair. The channelsignals flash when pairing and stop at the channel ID after complete pairing.4.After pairing, connect DC 12V power supply to both units,connect a monitor to Receiverand a hdmi video source device to the input of Transmitter.