Welcome to buy this product

Fitment:For Suzuki GSF600 Bandit 2000-2004For Suzuki GSF650 Bandit 2005-2006For Suzuki GSF1200 Bandit 2001-2006For Suzuki GSX600F Katana 1998-2006For Suzuki GSX750F Katana 1998-2006For Suzuki GSXR600 1997-2019For Suzuki GSXR750 1996-2019For Suzuki SV650 1999-2002For Suzuki VL800 Intruder Volusia 2001-2004For Suzuki XF650 Freewind 1997-2004Features:Condition:100% Brand NewLight Color: Red/Blue/Green1-6 Level IP68 Waterproof Gear displayLocate the Speed Sensor connector:The Speed Sensor is usually mounted on the front sprocket cover, and the 3-pole black speed sensor coupler is situated 20-40 cm (8”-16”) away from sensor.The connector is accessible by raising the fuel tank, removing the seat or a side fairing.Confirmation:1. Separate the Speed Sensor connector (you might need to use a small flathead screwdriver to get the connector apart). Rotate the rear wheel while ignition is on. The speedometer should indicate 0. If so, turn the ignition off and proceed to the next step. Otherwise, if the speedometer registers a speed other than 0, you have not disconnected the correct coupler and need to look again.2. After separating the Speed Sensor connector, plug in both the male and female 3-pole GFYSHIP harness connectors. Make sure the connectors are fully seated.3. Find the wire that comes from the Signal generator (Pickup coil / CKP sensor).If in doubt, check the bike’s Service Manual or ask your dealer.4. Connect the GFY Black/Green wire to this wire, using the Red wire tap connector supplied.Setup:You need to setup the module after installation. When ignition is turned on, the display counts backwards (6 to 1) indicating that the memory is clear.- Raise the rear wheel off the ground by using a stand, and start the engine in Neutral. (If you do not have a stand, you may setup the unit whileriding. Find a long, straight road with light traffic.)- The display will blink “1”.Select first gear, release the clutch, and keep the RPM above idle speed.The display is blinking faster while the unit is learning the gear.- When the display shows “2”, select second gear.Repeat this process until all gears are thought (5 or 6).The unit is programmed and should indicate the gears correctly.Now, when ignition is turned on, the display counts forward (1 to 6) indicatingthat it is fully functional.